Version 7.11.0.0 of Flex Out Now with the New Solution for Suzuki Mild-Hybrid

Download the newest version of the Flex software and enjoy the new solution for Suzuki Mild-Hybrid: work on Suzuki hybrid/petrol vehicles like Swift and Ignis.

As of today, you can program Bosch MG1CA002 control units in Bench: get access to the full content of Flash and EEPROM memories directly via the ECU connector and boost vehicle performance or remove diagnostic trouble codes.

Some of the supported vehicles:

• Suzuki Swith 1.2L MHEV R4 (90PS)
• Suzuki Ignis II 1.2L MHEV Dualjet (84PS)

This new protocol is available for the following software packages:

Bench  

• FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
• FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
• FLS0.5M – SW Flex Full Master
• FLS0.5S – SW Flex Full Slave
• FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
• FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave

Newly added protocols:  

(BENCH)  

• Suzuki Bosch MG1CA002 SPC5898 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup

Reading Time : ~ 3 minutes  Writing Time : ~ 5 minutes

Bug fixes

• Fixed writing error in some version of Kia / Hyundai CPEGD3.20.1 and CPEGP3.20.2
• Fixed writing error in Renualt Continental EMS3150 and EMS3155

Software improvements

• Added Bench support for Mazda Melco E6T6577x
• Added Bench support for PSA Bosch MED17.4.2 TC1767
• Added Boot support for FCA Marelli IAW5SF3

Discover the New solution for Suzuki Mild-Hybrid. Click here to discover the full list of supported vehicles.